Canon AE-1 Program This is Photography. With FD 50mm f/1.8 lens, action grip, battery, rubber. I prefer the AE-1 Program over the much older AE-1 because I. Download Songs Canon Ae 1 Vs Ae 1 Program Retro Camera only for review course, Buy Cassette or CD / VCD original from the album Canon Ae 1. DMCA Removal.

Step Remove loose dust and dirt from the camera using the brush prior to opening the camera or removing the lens. Address stains or sticky residue on the outside of the camera with a microfiber cloth slightly moistened with water. Use toothpicks and swabs to remove dirt and dust around the shutter/program dial and the film advance lever on the top right of the camera. For more aggressive cleaning, moisten cloths and swabs with alcohol or other solution. Step Lift the film rewind arm on the top left of the AE-1, and pull it up.

Use toothpicks and swabs in the same manner as Step 1 to clean in and around the arm and shaft. Corporate Treasury Management Ctm Program. Step Remove the lens and set it aside for the moment. Press the lens release button toward the bottom left of the lens when viewed from the taking position of the camera. Twist the lens up and toward the shutter release button to remove.

Step Use the blower bulb to softly remove loose debris inside the camera body. Hold the camera with the lens mount facing down to let gravity assist the process. Step Inspect the angled mirror.

The Warriors Castellano. The surface should be clean, reflective and free of dust and streaks. If necessary, use the brush and blower to remove as much debris as possible, then use your cleaning solution and a swab to gently clean the mirror surface.

Pano 2 Vr Crack there. Step Blow loose dust and debris from the viewfinder on the back of the camera. Use a swab dampened with cleaning solution to clean the glass of the viewfinder. Step Open the camera back by fully pulling up the film rewind knob. Gently brush or blow out loose debris, taking care around the shutter. Step Check the condition of the foam light seal around the opening. The camera door sits in a channel when closed, and the light seal assures complete darkness within the camera.

This foam degrades over time and it may be a source of debris in your camera. Step Clean the outside of the lens in the same manner as you did the camera body. The AE-1 uses mechanical lenses, so there are no electrical contacts to clean. Use either the lens pen or a cloth and solution on the glass surfaces of the lens, both the inner and outer surfaces. Step Open the battery compartment using the viewfinder cover which is stored in the camera's flash shoe. If this is no longer with the camera, a narrow, flat-bladed screwdriver will work. Insert either device into the slot on the side of the battery door on the front of the camera below the shutter button.